AST1029MP-960
Page 4
20/11/2006
MODEL AST1029MP-960 SOFTENER
THE MICROPROCESSOR CONTROL WILL REQUIRE BASIC DATA PROGRAMMING
TO SUIT THE WATER HARDNESS AND DESIRED UNIT CAPACITY
IMPORTANT:
IT IS ESSENTIAL THAT YOU READ THE GENERAL CONDITIONER
INFORMATION AND CONTROL SETTINGS OF THIS MANUAL BEFORE ATTEMPTING
TO SET THE FUNCTIONS OF THIS UNIT. THE DEALER OR AGENT CAN SUPPLY THE
RECOMMENDED HARDNESS CAPACITY. HOWEVER DO NOT EXCEED THE
MAXIMUM KILOGRAMS OF HARDNESS CAPACITY FIGURE IN TABLE 2.
Kilograms of Hardness
Capacity
Kg of Salt
Minimum 1.015
1.85
1.3
2.75
1.55
4
Maximum 2.03
7
SUGGESTED SALT SETTINGS
Table 2
Parameter
Name
Description
Range of
Values
Min.
Increments
Programming
For your
Application
Units of
Measure
Notes
P1
Time of day
AM or PM
1:00 to 12:59
1
Current time
Hour/
minute
Range depends on value selected
for
P13. Enter the current time.
P2
Time of day
Of
regeneration
1:00 to 12:59
AM to PM
1
2:00am
Hour/
minute
Range depends on value selected
for
P13. Skip this parameter to accept
the default or enter a new time.
P3
Hardness of
water
30 to 2500
1
10
Mg/l
Unit of measure depends on value
selected for P12. Test water
hardness and enter that value.
P4
Salt amount
01 to 25.5
0.5
0.1
Kilograms
Unit of measure and default
depends on value selected for P12.
Refer table 2.
P5
Capacity of
unit
0.01 to 14.00
0.1
0.01
Kilograms
Range depends on value selected
for
P12. Enter the unit capacity.
Table 1
PROGRAMMING PARAMETERS
To be done at time of commissioning
NOTE: All other parameters have been factory preset - DO NOT CHANGE
