INSTALLATION AND OPERATION INSTRUCTIONS
2
DC SERIES BOILERS / WATER HEATERS
DC 15-95, DC 15-96, DC 20-125, DC 33-160
SAFETY CONSIDERATIONS
Installation, start-up and servicing of IBC boilers / water heaters must
be done with due care and attention, and should only be performed by
competent, qualified, licensed and trained heating technicians. Failure to
read and comply with all instructions and applicable National and local
codes may result in hazardous conditions that could result in property
damage and injury to occupants which in extreme cases might result in
death.
HAZARDS & PRECAUTIONS
Supplied with the boiler / water heater
- The IBC boiler / water heater is
shipped with an accessory parts kit consisting of the following items:
•
1 x Wall Mounting Bracket, IBC Part # 250-647
•
1 x Condensate Assembly
•
1 x Pressure Relief valve, 3/4NPT, 30psi
•
1 x Outdoor Temperature Sensor
•
Air Vent and Relief Valve fittings
•
1 x Automatic Air Vent
•
4 x Lag Screws, Hex Head, Zn-Pl, 1/4 x 2-1/2 and Washers
•
1 x DC Installation & Operating Instructions
•
1 x DC/HC User Manual
•
1 x DC/HC Controller Manual
WARNING
If the information in this
manual is not followed
exactly, a fire or explosion
may result causing property
damage, personal injury, or
loss of life.
WARNING
Points out a potentially
hazardous situation which
must be avoided to prevent
serious injury or death.
CAUTION
Points out a potentially
hazardous situation which
must be avoided to prevent
possible moderate injury and/
or property damage
NOTE
Points out installation,
maintenance and operation
details that will result in
enhanced efficiency, longevity
and proper operation of your
boiler / water heater.
DANGER
Points out an immediately
hazardous situation which
must be avoided in order to
prevent serious injury or
death.
BEST PRACTICES
Points out recommendations
for better installation.
