DCX Series User’s Guide
Version 2.11 Rev. 0 13 August 2013
28
General Barcode Options
X037 t n a m k b c
t
barcode timeout value, 1 thru 9, default=5
n
0 = normalization off; 1 = normalization on, priority=small; 2 = normalization on, priority=large
a
0 = no alpha delete; 1 = alpha delete
m
0 = masking off; 1 = masking on
k
0 = kronos mode off; 1 = kronos mode on
b
0 = no good read beep; 1 = beep on a good barcode read
c
0 = don’t convert usic/cac cards; 1 = convert usic/cac cards
NOTES
The barcode timeout is a configurable parameter that adjusts the amount of time the reader waits after seeing a barcode before
it timeouts and processes the barcode. This value should be left at 5 which is the default, unless you have two barcodes next to
each other. In that case, the timeout value should be shortened.
Serial Settings
X014 b p ttt ttt
b
1 = 1200 baud
2 = 2400 baud
3 = 4800 baud
4 = 9600 baud (default)
5 = 19200 baud
6 = 38400 baud
7 = 57600 baud
8 = 115200 baud
p
1 = 8 data bits, no parity
2 = 7 data bits, even parity
3 = 7 data bits, odd parity
ttt
for future use, set to 000
ttt
for future use, set to 000
NOTES
Use this command to change the baud rate and parity/stop bits to something other than the default of 9600,N,8,1.
If you change these settings, you must restart the reader by cycling power, or use the restart command. THIS COMMAND IS
NOT VALID FOR DCX READERS USING TCP/IP.
