23
GB
GB
c) Refuel with the engine shut off. Do not remove the tank
cap or top-up fuel with the engine on or while it is still hot.
d) If fuel is spilt, do not turn on the engine. Move the
mower away from spill area.
Avoid ignition of any kind until petrol vapour is well
dispersed.
e) Securely close both the container and fuel tank with the
appropriate caps.
4. Replace the muffler if damaged.
- Before using, always visually inspect mowing deck,
blades, and blade bolts to make sure they are not worn or
damaged. If damaged, replace blades and bolts to
maintain equilibrium balance.
- Any time you leave the mower, or when the tractor is
stopped for maintenance checks, or is simply waiting,
always remember to remove starter key and apply park
brake.
Operation
1 Never start the engine in an enclosed area in which fumes
rich in carbon monoxide could accumulate.
2 Only cut grass during the day or with good artificial light.
3 Whenever possible, avoid using the mower on wet grass.
4 Be sure to constantly maintain a stable position on slopes,
and never exceed the maximum gradient indicated in this
manual.
5 Proceed at a constant speed.
6 Pay special attention when changing direction on a slope.
7 Do not cut grass on extremely steep slopes.
8 Use caution when moving in reverse.
9 Raise mowing deck when transporting the lawn tractor to
or from work area.
10 Do not use the mower if guards or protective casings are
defective. Make sure that all safety devices (micro
switches, guards, and grass collector) are in their correct
positions.
11 Before starting the engine, check:
- Tyre pressure (it must correspond to the figures indicated
in the "Technical specifications" table)
- Fuel and oil levels
- Cleanliness of the ventilation grills
- Correct positioning of the grass collector
- Any loose nuts or bolts
- Any missing pins or split-pins
12 Start engine carefully following the instructions.
13 Position the tractor on a flat surface before starting.
14 Never start engine in an enclosed space.
15 Never put your hands or feet near or under rotating
components. Always keep your distance from the
discharge tunnel.
16 Shut off the engine and remove starter key:
- before clearing blockages in the discharge tunnel;
- before performing any checks, cleaning, or work on the
mower;
- if you hit a foreign object. In this latter case, ensure that no
damage has been done to the tractor. Make any
necessary repairs before restarting and using the tractor;
- if the mower begins to vibrate excessively (check
immediately);
- whenever you leave the lawn tractor;
- before refuelling.
- Gradually reduce your ground speed and reduce the RPMs
to lowest level (using the throttle) before stopping
completely.
Maintenance
1. Frequently check that all nuts, bolts, and screws are
tightened to make sure the mower remains in a safe
operating condition.
2. Do not leave fuel in the tank when storing the lawn tractor,
since fumes could come in contact with an open flame or
spark.
3. Allow engine to cool before storing mower in an enclosed
area.
4. In order to reduce risk of fire; ensure that engine, muffler,
battery compartment, and fuel storage area are free of
grass, leaves, or excessive grease.
5. Frequently check collector hopper for wear or deterioration.
Also check that the collector grill is free of any residue
remaining from previous collection.
6. To keep your mower in safe condition, replace worn or
damaged components.
7. Always empty fuel tank outdoors.
Summary of Contents for Vision IB-VAC15C4H
Page 4: ...E Fig 5 2 Fig 6 1 Fig 6 2 Fig 6 3 Fig 7 1 4 1 2 3 4 mm 33 mm 45 mm 58 mm 70 A B ...
Page 5: ...5 Fig 7 2 Fig 7 3 Fig 7 4 Fig 7 5 Fig 7 6 Fig 7 7 ...
Page 6: ...6 Fig 7 8 Fig 8 1 Fig 8 2 15 Fig 8 3 Fig 8 4 Fig 8 5 ...
Page 8: ...8 Fig 8 10 Fig 8 11 70 Nm Fig 8 12 Fig 8 13 Fig 8 14 Fig 8 15 ...
