6.)
Take the new hood, camera and light diffuser.
Make sure the properly line up the factory light
fixture with the new hood. Line up the clips to
match the factory hood.
7.)
Run the wire from the camera through the clip
area of the light fixture.
8.)
Clip the light fixture back into place. Re-stick the
gasket back onto the housing to ensure a
watertight fitment.
9.)
Plug back into vehicle, run wire for the camera
through the door and into the vehicle. Run the
video wire to the front of the vehicle to the
monitor.
10.)
Plug into the video in or rear camera input.
11.)
Wire up the RED wire to reverse and BLACK
wire to chassis ground. Test trigger and video to
make sure the camera is operating correctly.
12.)
Re-assemble vehicle.
