16
Inspecting carbon brushes;
The motor employs carbon brushes
which are consumable parts. Keep the brushes clean so that they
move freely on the support. Remove and check the carbon
brushes quite often.
To inspect or replace the carbon brushes, use
a screwdriver to remove the rear cover and take out the carbon
brushes. Replace when they wear down to an extended limit since
an excessively worn carbon brush results in motor trouble.
Both carbon brushes should be replaced at the same time.
Use only identical carbon brushes.
The accessories or attachments included with the tool are
recommended only for use with this product. The use of any
other accessories or attachments might present a risk of injury to
persons. Only use accessory or attachment for its stated purpose.
This product does not contain any parts that can be repaired
by the consumer.
Contact an authorised service centre or a
similarly qualified person to have it checked and repaired.
Carbon Brush
compartment
IBL MC25-84
Summary of Contents for MC25-84
Page 1: ...MARBLE CUTTER MC25 84 ...
Page 2: ...1 ...
