12
This tool uses SDS Plus accessories (a cross-section of an SDS Plus
bit shank is shown).
INSERTING/REMOVAL OF BIT:
Insert the bit shank into the SDS Plus tool holder. Push the bit
down and turn it slightly until it fits into the slots.
Pull on the bit to check if it is properly locked. The hammering
function requires the bit to be able to move axially several
centimetres when locked in the tool holder.
To remove a bit, pull back the holder sleeve and pull out the bit.
To drill a wood or metal material using the 13 mm Hammer Drill
chuck, first attach the drill chuck to the chuck adaptor as shown in
the figure. SDS-plus shank should be same as the drill bit used and
so follow the steps referred above.
INSERTING AND REMOVING SDS PLUS ACCESSORIES
IBL RH26-26/24
FITTING THE CHUCK ADAPTER AND CHUCK
Drill Chuck +
Chuck Adaptor
Chuck wrench; used for tightening
or loosening the jaws of a chuck.
SDS Plus shank
cross-section
