INSTALLATION GUIDE
2022-1.0
IBEX EQUIPMENT CO
TX31 Drawbar Add-on Kit
Align the end of the drawbar shown in (Fig. 1) with the baler's top link bracket.
The drawbar will fit inside the baler's top link bracket and will be supported by
the welded tabs on each side. Once aligned, you can insert the top link pin
through the baler's top link bracket going through the drawbar's holes. Secure
the top link pin with a retaining clip seen in (Fig. 2).
Figure 1
Figure 2
Locate the crossbar with multiple holes and category 1 pins on each end. Attach
this crossbar to your tractor's lower three point hitch lift arms by inserting the
pins into the lift arms as shown in (Fig. 3). Make sure to secure them with the
retaining clips once installed (Fig. 4).
