C – Adjusting output set values when unit
is in START mode
1. While the unit is running, depress the SET/OUT switch
(#1)
. As soon as this
switch is activated, the output LEDS display last output set values.
2. The volts LED
(#5)
is blinking at first. Increase or decrease voltage by
pressing of the two SET switches
(#8)
.
3. Depress VOLTS/mA switch
(#2)
in order to select mA. The mA Led
(#6)
is blinking. Increase or decrease current by pressing one of the two SET
switches
(#8)
.
4. Press SET/OUT switch
(#1)
for displaying the new actual values.
5. When separation is terminated, press START/STOP switch
(#9)
to stop the
run.
6. Turn off the power supply by using the main power switch located on the
rear panel.
FURTHER INSTRUCTION
1. To view the set values during the run, depress the SET/OUT switch.
The LED displays the set values as long as this switch is depressed.
Once the SET/OUT switch is released, the LED will display the output values
for three seconds, and then will switch back to displaying the actual output
values.
2. It is possible to change the values during the run
without
depressing the
STOP switch.
3. To change the output set values during the run or in STOP status:
• Depress the SET/OUT switch
(#1)
. As soon as this switch is activated,
the output LED display last output set values.
• The volts LED
(#4)
is blinking at first. Increase or decrease voltage by the
help of the two SET switches
(#8)
.
• Depress V/mA switch
(#2)
in order to select mA. The mA Led
(#6)
is
blinking.
• Increase or decrease current by pressing one of the two SET switches
(#8)
.
• After 3 seconds, the new actual output values are automatically displayed.
• To immediately read the new actual values, press SET/OUT switch.
4. In START status, when the SET/OUT switch is depressed, the LEDS display
the output set values for three seconds and then switch back to displaying
the actual output values.
5. To establish the limiting (constant) mode for the particular experiment, set
the controlling parameter to the output desired, and increase the other output
set value until the appropriate mode LED (Constant voltage or Constant
current) illuminates.
12
