ibiMaster 250 / ibiMaster 250e
Getting started
250 only:
Push the handle (A) (fig. 1a) onto the
punching shaft located on the right side of the
machine. Align the flat spot of the handle with the flat
of the shaft.
Secure handle with screwdriver.
250e only:
Firmly push the female end of the power
cord into the power cord receptacle located at the
back of the machine.
CAUTION:
Make sure this step is complete prior to
plugging the male end of the power cord
into a power receptacle.
Plug the male end of the power cord into an
appropriate power receptacle.
1
2
3
4
Determine sheet width
Set Edge Guide (B) to paper size you wish to bind
(11”, 8-1/2” letter size, 11-1/4” oversized cover,
A4 ring, A5, Japan A4) (see figure 1a/1b).
1
250e only - Cleaning
CAUTION:
Unplug this product before cleaning.
• Wipe exterior only with a damp cloth.
Do not use detergents or solvents.
The following notes apply only to the units
rated 230 V 50Hz.
MAIN CORDSET SELECTION
(FOR 230 AV MACHINES ONLY)
When choosing a detachable line cord for use with the
ibiMaster 250e, always observe the following:
The cordset consists of three components; the attachment
plug, cordage and appliance inlet. Each of these
components must meet European regulatory approvals
for safety.
The following
minimum
electrical ratings for the specific
cordset are published for safety purposes.
DO NOT USE CORDSETS THAT DO NOT MEET THE
FOLLOWING MINIMUM ELECTRICAL REQUIREMENTS.
PLUG:
3 A, 250 Volts, 50/60 Hz, Class 1,3 conductor,
European safety agency approved.
CORDAGE:
Type H05W-F3G0.75, Harmonized ( HAR ).
The “
” symbols indicate cordage approved to
appropriate European standard (NOTE: "HAR" may be
substituted by the approval mark of the European safety
agency which approved the cordage. An example would
be “ VDE ”.
APPLIANCE CONNECTOR:
3 A, 250 Volts, 50/60 Hz,
European safety approved, Type IEC 320. Cordset shall not
exceed 3 meters in length. Cordset with component
electrical ratings greater than the minimum specified
electrical ratings may be substituted.
General safeguards
• Use the unit only for its intended purposes.
• Do not place anything in the punch opening of the
machine other than paper and cover stock.
• Place unit on a secure, stable work area to prevent the
unit from falling and possibly causing personal injury
and damage to the unit.
• Follow all warnings and instructions marked on the unit.
• Lift the machine from the bottom, not the cover.
• Do not lift the machine by the cover or paper holder
wire.
EDNord - Istedgade 37A - 9000 Aalborg - telefon 96333500
