© 2002 IBICO
Operations Manual
Patriot 12HR, 25HC, 38HC
Page 5-7
5.5 Film alignment
The film supply shafts come with pre alignment holes on
the right side.
Patriot 12HR - Has pre alignment holes for 9 in. (21 cm)
and 12 in. (31 cm) film widths.
Patriot 25HC - Has pre alignment holes for 9 in. (21 cm),
12 in. (31 cm), 18 in. (46 cm) and 25 in
(64 cm) film widths.
Patriot 38HC - Has pre alignment holes for 9 in. (21 cm),
12 in. (31 cm), 18 in. (46 cm), 25 in
(64 cm) and 37 in. (95cm) film widths.
Loosen the thumb screw on the right side core adapter
and move to the corresponding hole to match the width
of your roll of film. Tighten the thumb screw in the pre
drilled hole.
Core adapters
Thumb screws
5.6 Tension knobs
Allows the operator to increase or decrease film web
tension as necessary to reduce curl and wrinkles. Refer
to Section 4.6 Adjusting film tension for more information
on tension.
To increase tension
1.
Turn the tension knob as indicated below.
To decrease tension
1.
Turn the tension knob as indicated below.
