© 2002 IBICO
Operations Manual
Page 7-2
Patriot 12HR, 25HC, 38HC
7.3 Troubleshooting
As an operator, you can perform some basic
troubleshooting before contacting your local service
representative.
WARNING: Never remove the cabinets in attempt
to troubleshoot the laminator. You may cause damge
to other components or injury to yourself.
ELECTRICAL HAZARD: Do not remove the
cabinets. You will be exposed to dangerous voltage
which can shock or paralyze you.
CAUTION: Only trained technicians should perform
service related work on the laminator.
Refer to Figure 7.3.1 Troubleshooting Guide on page
7.3.
WARNING: Never clean the rollers with sharp or
pointed objects.
1.
Remove the film from the laminator.
2.
Preheat the laminator until the READY indicator
illuminates.
3.
Rub the top and bottom heat rollers with a 3M
TM
Scotch-
Brite
TM
pad.
4.
Install the feed table and lower the safety shield.
5.
Press RUN to rotate the heat rollers to a new area for
cleaning. Press STOP. Continue this process until the
complete surface of both rollers are clean.
6.
Follow the procedure in Section 4.6 Film loading and
threading to reload the laminator.
