Copyright Velocomp LLP 2005-2013
3
PART ONE:
Easy Start
Getting your going is faster and easier than ever. Here’s what you will
do:
1)
Charge your ’s battery
2)
Attach the mount to your bicycle
3)
Attach the speed-cadence sensor to your bike
4)
Calibrate your with an easy 10-15 minute ride
THAT’S IT!!! Details on each step follow.
1. Charge your ’s battery
Your includes a rechargeable battery. The battery is permanently installed in the
case and cannot be removed.
Before using your for the first time,
make sure to fully charge your battery
.
Attach the USB cable to the connector located on the bottom of the case, then
plug in the USB connector to your computer port, or to any USB power source. While
charging, the middle window will show “batt%” and the bottom window will flash “chrg”
(charging), followed by the percentage charge of your battery.
When your is fully
charged the bottom window will show “100” (100%).
Your battery will charge fully in about 2 hours.
A note on battery life
Your battery will provide you about 20 hours of continuous ride time between
recharges, in cold weather or warm.
Of course, each time you plug your into your computer, or any USB charger
device, the battery will recharge very quickly.
You can check the percentage of battery energy remaining in your by clicking the
left arrow one time to find “Batt %”. The amount of battery charge in your is
shown in %. Wait a few seconds for the battery charge indication to stabilize.
TIP:
While in the battery screen you can turn your off by press-holding the
center button.
TIP:
During the winter months and the “off” season, recharge your once every
two weeks. This will extend battery life.
You can return your to the main screen by clicking the center button.
