MANUAL - UHF MICROPHONE SYSTEM
3
RECEIVER REAR PANEL
6.
Antenna
7.
Balanced audio output
8. Mix out
9. 12V𝌃 input jack
TRANSMITTERS
HANDHELD MICROPHONE
10.
LCD display
11.
Power switch
BELT-CLIP TRANSMITTER
(HS20-UHFA/HS20-UHFB
12.
Antenna
13.
Power switch: Press the button for 2-3 seconds
to turn on. The LED lights up. Press again for
2-3 seconds to turn off.
14.
Microphone input connector
15.
LED indicator: Lights when the unit is turned
on. Flashes when the battery power runs low
16.
LCD display: Shows frequency
17.
Battery compartment
18.
Battery cover
INSTALLING THE BATTERIES IN THE MICROPHONE/BELT-CLIP TRANSMITTER
Remove the battery cover and insert 2x AA size batteries ensuring correct
polarity
RECOMMENDATIONS FOR BATTERIES
This symbol indicates that used batteries should not be disposed of with
household waste but deposed correctly in accordance with your local regulations..
Batteries shall not be exposed to excessive heat such as sunshine, fire or the like.
When the internal batteries are not to be used, remove them to avoid damage caused by battery leakage or corrosion.
ATTENTION
: Danger of explosion if battery is incorrectly placed.Only replace by the same or equivalent type.
WARNING
:Keep new and old batteries out of the reach of children.
If the battery compartment doesn't close properly, stop using the product and keep it out of the reach of children.
If you are in doubt whether the batteries have been swallowed or introduced into any other part of the body, contact imme-
diately a doctor.
