MANUAL - CUBE15A-ARRAY
3
pliance. Do not obstruct the air circulation with objects such as magazines, table cloths or curtains. This
prevents the dissipation of heat from the appliance and can result in overheating.
•
Only use the appliance in a moderate climate, not in tropical environments.
•
All persons involved in operating, installing and servicing the appliance and putting it into service must be
trained and qualified accordingly and observe these operating instructions.
•
Defective mains cables may only be replaced by specialists. Danger of shock hazard!
•
Do not leave the packaging material lying around carelessly since it can become a source of danger for child-
ren playing with it.
•
The accident prevention regulations and the regulations of the employers’ liability insurance association
should be observed at commercial institutions.
•
If you are not sure about the correct connection or if questions arise which are not answered by the operating
instructions, please do not hesitate to contact support or a specialist of your choice. Consult a specialist if
you are in doubt the operating principle or the safety of the product.
MEDIAPLAYER
1.
MODE
: Press this button to switch among all input modes
2.
PREV
: Press this button to go back to previous track
3.
Play/Pause
: Press this button to pause the playing. Press again to play
4.
NEXT
: Press this button to go to next track
5.
REPEAT
: Press this button to repeat all tracks, repeat current track or play random tracks
6.
Mute
: Press this button to mute the unit
7.
SD
: Connect your SD card here
8.
USB
: Connect your USB card here
9.
MIC VOL
: Use this knob to adjust the volume of microphone
10.
MIC ECHO
: Use this knob to adjust the echo of microphone
11.
TREBLE
: Use this knob to adjust the treble of output
12.
BASS
: Use this knob to adjust the bass of output
13.
SUB VOL
: Use this knob to adjust the volume of sub output
14.
Master VOL
: Use this knob to adjust the master volume
REAR PANEL CONNECTIONS
1.
MIC INPUT:
Connect your microphone here
2.
LINE INPUT
: Connect your line signal here
3.
AUX INPUT
: Connect your AUX signal here
4.
AUX OUTPUT
: Connect this line output signal to the input of another amplifier or active speaker.
5.
SAT1 OUTPUT:
Connect this output to the satellite 1 speaker.
6.
SAT2 OUTPUT:
Connect this output to the satellite 2 speaker.
CUBE15A-ARRAY
BT
MEDIAPLAYER
MINIMUM LOAD 8 OHMS
LOCK
OUT
AUX IN
MIC
MIC VOL
MIC ECHO
TREBLE
VOLUME
MODE
REPEAT MUTE/
+
-
BASS
SUB VOL
VOLUME
LINE
USB
SD
INPUTS
SPEAKER OUTPUT
LOCK
SAT 1 OUT.
SAT 2 OUT.
