3
CHANNEL CONTROL SECTION:
1. GAIN control
Adjustment of the input signal level for
channel 1 & 2
2.
TREBLE control
Adjustment of the high frequencies for
channel 1 & 2
3. BASS control
Adjustment of the low frequencies for
channel 1 & 2
4. MIC volume control
5. HEADPHONE volume control
6. MASTER volume control
7. Crossfader:
Set the crossfader to the
left side to mute the LINE 2 input signal or
move the crossfader to the right side to
mute the LINE 1 input signal. If the crossfader is in the middle position, both LINE 1 input signal & Line 2
input signal will be mixed and sent to OUTPUT Jacks
8. POWER LED
: Lights up when the unit is powered.
REAR PANEL CONTROLS:
1.
12V Power supply: Connect the adapter here
2.
Master output: Connect this RCA output to the
RCA input of an amplifier or active speaker
3.
REC output: Connect this RCA output to the RCA
input of a tape recorder, amplifier or active
speaker.
4.
Line 2 RCA input: Connect the Line 2 Signal here
5.
Line 1 RCA input: Connect the Line 1 signal here
FRONT PANEL CONNECTORS
6.
MIC input: Jack 6.35mm. Connect the microphone here
7.
Headphone output: Jack 6.35mm. Connect the
headphone here
Electric products must not be put into household waste. Please bring them to a recycling centre. Ask
your local authorities or your dealer about the way to proceed.
