General information
After turning the ignition key the iBlue Immobilizer prevents the engine from starting until
the operator of the vehicle approves this on his/her smartphone using the mobile applica-
tion specially designed to control the immobilizer.
The device can be installed in all vehicles equipped with a 12V nominal voltage battery and
use common negative ground.
WARNING!
The immobilizer can only be installed by a qualified automotive electrician expert, in line with
these use and installation instructions as the proper installation of the product cannot be
ensured in any other manner and that the meeting of this requirement does not represent
a disproportionate burden for the consumer. The unprofessional installation or transforma-
tion of the immobilizer jeopardises the secure operation of the vehicle. The manufacturer
and distributor of the iBlue Immobilizer disclaim
responsibility for any and all damage arising from
improper, mistaken or unprofessional installation
and commissioning. The installing expert must
fully complete the attached installation certificate
and hand it over to the operator of the vehicle
after installation is completed. Please, take extra
care to retain the installation certificate, as this is
needed for enforcing possible consumer claims
with regard to the immobilizer.
Directions for installation
WARNING!
The immobilizer can only be installed by a qualified automotive electrician expert, in line with
these directions for installation. The immobilizer can only be installed in a vehicle with an intact
electrical system that is in a good state of repair. When installing the immobilizer, the installing
expert must verify that this is the case and if these conditions are not in place, he must reject
the installation.
The immobilizer can be used to interrupt the circuits of two units needed to start the engine.
The device must be installed within the passenger compartment of the vehicle when voltage
is turned off. The place of installation must be protected in mechanical and electric terms,
from both leaking liquids and vapours. The place must be free of moving parts and ambient
temperature must be within the operating temperature range.
BEWARE!
Risk of injury
It is recommended to install the immobilizer when voltage is turned off. When connect-
ing to the vehicle’s wires use welded joints for all wires. The wires must be insulated, as
any rupture, dropping, decoupling or any other similar event can cause the vehicle to stop
immediately representing an increased risk of accident. The improper, mistaken or unpro-
fessional installation and commissioning of the immobilizer also represents an increased
risk of accident.
ENGLISH
Summary of Contents for immobilizer
Page 1: ...Immobilizer User Guide ...