iBlue immobilizer, User Manual

WARNING!
During installation the installing expert must verify that the circuit of which is interrupted 

by the immobilizer does not trigger an error code in the on-board computer of the vehicle 

that aff ects the operational capability of the vehicle. It is important to power the immobilizer 

from a wire that is  controlled by the ignition switch and provides constant power during the 

start up procedure. Once installation is complete, after having become familiar with informa-

tion outlined in the chapter on using the smartphone application, the operator of the vehicle 

should verify if it really is possible to prevent the starting of the engine.

The wiring diagram of iBlue Immobilizer
Wiring is summarised in the following table:

Wire number   

Function

            1 

+12V (ACC)

            2 

Earth

            3 

Relay 1 output A

            4 

Relay 1 output B

            5 

Relay 2 output A

            6 

Relay 2 output B

Maintenance
The device does not require any maintenance.

Functions of the iBlue Immobilizer
If turned on/armed, the immobilizer prevents the starting of the engine after turning the ignition 

key. The device remains turned on/armed until we enter the proper PIN code. After entering the 

proper PIN code, the device is disconnected.

When disconnected, the immobilizer does not prevent the starting of the engine. It is only possi-

ble to terminate the disconnected status by turning ignition off . Within 30 seconds after ignition 

is turned off , the immobilizer gets armed automatically. 

ENGLISH

1 2 3 4 5 6