103
¹
107
103
There are multiple LAN Adapters in the system. Please
specify the correct serial number in NET.CFG.
Operator Response: Add the serial number of the adapter to the
NET.CFG file.
107
LAN Adapter failed the media test. Please check the cable
and reboot the system unit.
Operator Response: Verify that the network cable is correctly connected to
the adapter and reboot the system to run RPL again.
Refer to the adapter's documentation for additional information about cabling.
Standard Messages
These messages could be displayed during standard RPL operation.
RPL-ROM-ADR: xxxx xxxx xxxx
Explanation: The values displayed in the place of xxxx xxxx xxxx indicate
the 12-character hexadecimal node address of the installed adapter. This
address might be required for your RPL server to respond to your adapter.
Operator Response: You might need to supply this address to your server.
RPL-ROM-ERR: BADA; RPL Halted
Explanation: This message indicates that the RPL server sent a File Data
Response frame with a Locate or Transfer address that is not valid.
Operator Response: Check your server configuration and retry. On a
NetWare server, set the ACK bind time parameter for this requester. Refer
to your NetWare documentation for information on setting the ACK
parameter.
RPL-ROM-ERR: DExx; RPL Halted
Explanation: This message indicates that an internal error occurred in the
RPL function.
Operator Response: Retry the operation. If you still experience problems,
refer to your adapter’s installation manual for information about obtaining
service for your adapter.
Chapter 3. Dynamic Host Configuration Protocol and Remote Program Load
3-7
Title: ASB3CNTL CreationDate: 07/16/98 18:07:52