RPL-ROM-IRQ:
¹
RPL-ROM-SFC:
RPL-ROM-IRQ: nn
Explanation: A decimal field that indicates the interrupt level being used by
your adapter.
Operator Response: No action required.
RPL-ROM-PIO: xx
Explanation: A 2-byte, hexadecimal field containing the programmed I/O
(PIO) address being used by your adapter.
Operator Response: No action required.
RPL-ROM-SEQ: nnnn
Explanation: A decimal field containing the number that specifies the last
valid sequence number received from the LAN server. The sequence
number is included in each frame of the image file sent by the server to the
RPL requester.
Operator Response: No action required.
RPL-ROM-SFC: nnnn
Explanation: A decimal field indicating the number of Send File Request
frames sent by the your adapter to the RPL server. An excessive number of
Send File Request frames indicates that the RPL server is not responding
after it has been found.
Operator Response: Check your RPL server configuration.
DHCP Configuration
THe DHCP (Dynamic Host Configuration Protocol) function provided
with this Flash module enables a PC using an IBM 10/100 EtherJet
PCI Adapter to download its configuration from a DHCP server.
Among the information that can be downloaded from the DHCP
server to a DHCP client is the IP address of the client, the subnet
mask and the default gateway. The DHCP process uses the TCP/IP
protocol. DHCP allows for dynamic allocation of client network
addresses and configurations.
The following requirements must be met in order for the DHCP
process to operate:
Chapter 3. Dynamic Host Configuration Protocol and Remote Program Load
3-9
Title: ASB3CNTL CreationDate: 07/16/98 18:07:52
