1. A DHCP server that is configured for DHCP client support must
be active on the network. Supported servers are:
¹
Intel LANDesk Configuration Manager (LCM). For additional
information, point your web browser to
http://www.intel.com.
|
¹
IBM's LAN Client Control Manager 2.x (LCCM 2.x). For
|
additional information, point your web browser to
|
http://www/us.pc.ibm.com.
2. The adapter in the DHCP client PC must have the DHCP feature
installed. Use the Flash module to install the DHCP feature.
Notes:
1. The DHCP feature should be enabled on only one IBM 10/100
EtherJet PCI Adapter in any computer.
2. If the DHCP/RPL Flash module is installed in the IBM 10/100
EtherJet PCI Adapter and you program the Flash module as
described in “Programming the Flash Module” on page 3-4, the
adapter will attempt to RPL or perform a DHCP boot. This will
happen every time your system unit boots.
| 3. With the DHCP PXE code in the Flash module, it is normal to
|
see one of the following messages during bootup, even if you
|
are not running remote boot:
|
PXE-M04: Initializing network boot device using interrupt
|
18h.
|
PXE-M04: Hooking bootstrap interrupt 18h.
|
This is to inform the user that the Flash module on the adapter is
|
ready for PXE boot operation.
3-10
10/100 EtherJet PCI Adapters
Title: ASB3CNTL CreationDate: 07/16/98 18:07:52