Table 10 (Page 2 of 2). SNA Token-Ring Attachment Worksheet
Item
Available Values
Selected Value
MAC (Medium Access Control)
Read-only field
Notes:
ñ
Eight characters maximum; 0–9, A–Z, $, #, and @ permitted, but the first character cannot be 0-9.
ò
Printer prefixes with 0500 0000.
ó
Do not enter the spaces shown; they are included here as a visual aid.
Install status
An indication of whether the attachment is installed.
XID number
An ID that distinguishes a specific piece of equipment from all other similar pieces
of equipment on the network.
Remote network name
The network name associated with the remote logical unit. The first character of
this name cannot be 0-9.
SNA intervention timer
The amount of time the operator is allowed to correct recovery-required errors (such
as paper jams) before the printer notifies the host that the attachment is not
operating. The timer can be set from 0 to 98 minutes. To turn the timer off, specify
99 (the default value).
Local LU name
The name of the local logical unit involved in the session.
Remote LU name
The name of the remote logical unit involved in the session. The first character of
this name cannot be 0-9.
Mode name
The name of the SNA mode that describes the characteristics of a session. The
first character of this name cannot be 0-9.
Remote address
The remote host Token-Ring adapter card address.
Local network name
The name of the network associated with the local logical unit. If you enter a local
network name, you must also enter a control point name. The first character of this
name cannot be 0-9.
Control point name The name of the application control point. The first character of this name cannot
be 0-9.
Alternate address (Local Adapter Address)
The LAN adapter unique address for the printer. The address must be different
from other addresses on the LAN.
Ring speed
The ring speed of the network the adapter is attached to. An incorrect value can
cause the network to stop operating.
SSCP ID
The ID of the controlling system services control point in the SNA network. The
3160 uses this ID to send information to the host system's Netview programs. If the
host does not use Netview, set SSCP ID to 0000.
Note: Specify SSCP ID as a hexadecimal value. If the corresponding host value is
in decimal, you must convert it to hexadecimal.
Local LU address
The destination address used by other systems to send information to the local
logical unit.
Chapter 5. Configuring the Printer and Its Attachments
27
Summary of Contents for 3160
