© Copyright IBM Corporation 2019, 2020. Customer Install Guide, 2U Chassis
23
Chassis Installation Procedure
Pay Attention!
All components must have the same airflow direction when installed in the rack.
Cold air enters at the front of the rack and exits at the rear of the rack. A mismatch in
the air flow direction will affect the heat dissipation. Switches must plan for power
supply-to-connector airflow. i.e. switch network connections must be facing the rear of
the rack.
Read the
Rack safety notices
, Pub # G229-9054 included with the unit.
C010 - This unit weighs approximately 121.2lb (55kg). IBM recommends the use of
an appropriate lifting device to position the chassis on the
rails.
Rack rail parts inventory
The enclosure comes with all of the hardware that is necessary for you to install
the enclosure in the rack cabinet. The following illustrations display the items that
you need to install the enclosure in the rack cabinet. If any items are missing or
damaged, contact your place of purchase.
The slide box kit includes the following parts. This kit comes with the enclosure.
One right slide
One left slide
Two M5 screws
Two washers