© Copyright IBM Corp. 2000
17
Chapter 3. Starting the server
Startin
g the s
erver
After you plug the power cord of your server into the power supply and an electrical
outlet, the server can start in several ways:
•
You can press the Power control button on the front of the server to start the
server.
Note:
After you plug the power cord of your server into an electrical outlet,
wait approximately 20 seconds before pressing the Power control
button. During this time, the system-management processor is
initializing and the Power Control button does not respond.
•
If the server is turned on, a power failure occurs, and unattended-start mode is
enabled in the Configuration/Setup utility program, the server will start
automatically when power is restored.
•
If AC power is present, the server is off, and the wake-up feature is enabled in
the Configuration/Setup utility program, the wake-up feature will turn on the
server at the set time.
•
If AC power is present, the server is off, and ring signal detect is enabled in the
Configuration/Setup utility program, you can turn on the server by telephone
input.
•
The Netfinity Advanced System Management Processor also can turn on the
server.
Statement 5
CAUTION:
The power control button on the device and the power switch on the power
supply do not turn off the electrical current supplied to the device. The device
also might have more than one power cord. To remove all electrical current from
the device, ensure that all power cords are disconnected from the power source.
1
2
Summary of Contents for 5100
