5. Move to the front of the rack. Align the left rack rail inside the rack cabinet by resting the rail bracket
hooks on the rack flange holes that you previously marked. The rail hooks are located in the flange
hole in the middle of each EIA rack unit.
6. With the rail bracket hooks resting on the rack flange holes, press down on the rack rails until the rail
pins click into place.
7. Repeat these steps for the right rack rail.
8. Move to the rear of the rack. Extend the left rack rail inside the rack cabinet until it hooks the rack
flange holes that you previously marked.
9. Press down on the rack rails until the rail pins click into place.
10. Repeat these steps for the right rack rail.
11. Move to the front of the rack. Secure the rails to the rack by fastening one screw through each hole in
each rail and through the EIA support flange.
Installing the 5104-22C, 9006-22C, or 9006-22P system into the rack and connecting and
routing power cables
After you install the system onto the rails in the rack, connect and route power cables.
About this task
Note: This system requires three people to install the system into the rack.
Procedure
1. Remove the protective plastic film from the top of the system chassis.
2. Move to the front of the rack.
3. Extend each rail until it clicks into the extended position.
4. Using three people, lift the system and align the system chassis rails on each side of the chassis with
the rack slide rails.
5. While one person is supporting the weight of the system, have the second person gently push the
system into the rack, until you hear each slide rail click into place.
6. Simultaneously depress the slide rail latches on each side of the slide rail and push the system
toward the rear of the rack until the system clicks into place.
Installing and configuring your system and system features 7
Summary of Contents for 5104-22C
