3.
Press the power button (A), as shown in the following figure, on the control panel.
v
A
: Power-on button
– A constant light indicates full system power to the unit.
– A flashing light indicates standby power to the unit.
– There is approximately a 30-second transition period from the time the power-on button is
pressed to when the power LED goes from flashing to solid. During the transition period, the
LED might flash faster.
v
B
: Enclosure identify light
– A constant light indicates the identify state, which is used to identify a part.
– No light indicates that the system is operating normally.
v
C
: System information light
– No light indicates that the system is operating normally.
– Light on indicates that the system requires attention.
v
D
: Enclosure fault roll-up light
– A constant light indicates a fault in the enclosure.
– No light indicates that the system is operating normally.
v
E
: Eject button
v
F
: Function/Data display
v
G
: Pinhole reset button
v
H
: Decrement button
v
I
: Enter button
v
J
: Increment button
4.
Observe the following aspects after pressing the power button:
v
The power-on light begins to flash faster.
A
B
C
D
E
F
G
H
I
J
Front View
Top View
P8HB5500-1
Figure 25. Control panel
28
Power Systems: Installing the Model 024, ESLL, or ESLS storage enclosure
Summary of Contents for 5147-024
