IBM 6.1.8.2 Hardware Planning And Installation Manual Download

Page: 30 / 114

4. Lift by standing or by pushing up with your leg muscles; this action removes the strain from the

muscles in your back. Do not attempt to lift any objects that weigh more than 18 kg (40 lb) or objects

that you think are too heavy for you.

• Do not perform any action that causes a hazard or makes the equipment unsafe.
• Before you start the device, ensure that other personnel are not in a hazardous position.
• Place removed covers and other parts in a safe place, away from all personnel, while you are servicing

the unit.

• Keep your tool case away from walk areas so that other people cannot trip over it.
• Do not wear loose clothing that can be trapped in the moving parts of a device. Ensure that your sleeves

are fastened or rolled up above your elbows. If your hair is long, fasten it.

• Insert the ends of your necktie or scarf inside clothing or fasten it with a nonconducting clip,

approximately 8 cm (3 in.) from the end.

• Do not wear jewelry, chains, metal-frame eyeglasses, or metal fasteners for your clothing.

Remember: Metal objects are good electrical conductors.

• Wear safety glasses when you are hammering, drilling, soldering, cutting wire, attaching springs, using

solvents, or working in any other conditions that might be hazardous to your eyes.

• After service, reinstall all safety shields, guards, labels, and ground wires. Replace any safety device

that is worn or defective.

• Reinstall all covers correctly after you have finished servicing the unit.

Inspecting the system for unsafe conditions

Use caution when you are working in any potential safety hazardous situation that is not covered in the

safety checks. If unsafe conditions are present, determine how serious the hazards are and whether you

can continue before you correct the problem.
Before you start the safety inspection, make sure that the power is off, and that the power cord is

disconnected.
Each device has the required safety items that are installed to protect users and support personnel from

injury. Only those items are addressed.
Important: Good judgment must also be used to identify potential safety hazards due to the attachment

of non-IBM features or options that are not covered by this inspection guide.
If any unsafe conditions are present, you must determine how serious the apparent hazard might be

and whether you can continue without first correcting the problem. For example, consider the following

conditions and their potential safety hazards:
Electrical hazards (especially primary power)

Primary voltage on the frame can cause serious or lethal electrical shock.

Explosive hazards

A damaged CRT face or a bulging capacitor can cause serious injury.

Mechanical hazards

Loose or missing items (for example, nuts and screws) can cause serious injury.

To inspect each node for unsafe conditions, use the following steps. If necessary, see any suitable safety

publications.

1. Turn off the system and disconnect the power cord.
2. Check the frame for damage (loose, broken, or sharp edges).
3. Check the power cables by using the following steps:

a) Ensure that the third-wire ground connector is in good condition. Use a meter to check that the

third-wire ground continuity is 0.1 ohm or less between the external ground pin and the frame

ground.

b) Ensure that the power cord is the appropriate type, as specified in the parts listings.

10 IBM Storage Scale System Utility Node: Hardware Planning and Installation Guide