To remove a simple-swap hard disk drive, complete the following steps:
1. Read the safety information that begins on page vii and “Installation guidelines”
2. Turn off the system-board tray and all attached devices (see “Turning off the
system-board tray” on page 21).
3. Remove the filler panel from the bay that contains the simple-swap hard disk
drive.
4. Pull the loops of the drive toward each other; then, pull the drive out of the drive
bay.
Note:
A hard disk drive or filler panel must always be installed in each drive
bay when the server is turned on. In each drive bay that contains a simple-swap
hard disk drive, a filler panel must always be installed in addition to the drive.
5. Store the drive and filler panel for later use.
Removing a 2.5-inch hot-swap hard disk drive
Note:
The following illustration shows how to remove a 2.5-inch hot-swap hard disk
drive from a 2U chassis.
Note:
You do not have to turn off the server to remove a hot-swap drive.
Chapter 3. Installing optional devices
31
Summary of Contents for 6380
