Adapter guide
9. Follow the instructions that come with the adapter to set any jumpers or
switches.
10. Carefully grasp the adapter by the top edge or upper corner, and insert it in the
two-slot riser card. Align the adapter with the connector on the riser card; then,
press the adapter firmly into the connector.
11. If you have another adapter to install, do so now. Otherwise, continue with step
12. If any cables must be connected to an adapter, connect them. Route these
cables through the hole at the side of the expansion enclosure.
13. Align the tabs on the PCIe adapter bay cover with the holes on the expansion
enclosure; then, slide the PCIe adapter bay cover toward the rear of the
expansion enclosure until it stops.
14. Install the PCIe adapter bay cover screws.
If you have other devices to install or remove, do so now. Otherwise, go to
“Completing the installation” on page 45.
Installing a hard disk drive
The dx360 M2 server configurations support installation of four hard disk drive
types. The following sections describe the installation of each type of hard disk
drive.
Installing a 3.5-inch hot-swap hard disk drive
Note:
The following illustration shows how to install a 3.5-inch hot-swap hard disk
drive in a 3U chassis.
36
System x iDataPlex dx360 M2: User's Guide
Summary of Contents for 6380
