2.
Click
Actions
>
Service and Support
>
Control Panel Functions
>
(20) Type, Model, Feature
.
3.
(20) Type, Model, Feature
displays the machine type, model, and feature code of the managed server.
Also displayed are the CEC IPL Type and the FSP IPL Type for the managed server.
Preparing for Hot Repair or Upgrade
Use this task to see a summary of required actions that must be performed in order to isolate a particular
hardware component as part of a service procedure.
1.
On the
Welcome
page, under the
Resources
tab, select the server.
2.
Click
Actions
>
Service and Support
>
Hardware
>
Prepare for Hot Repair or Upgrade
.
3.
Select the base location code that contains the field-replaceable unit (FRU) to be serviced or the GX
adapter to be replaced.
4.
Click
Next
.
5.
Select either
Delay the service procedure
or
Continue the service procedure non-concurrently
> click
Next
.
6.
Click
OK
.
Exchange FRU
Use this task to exchange one field-replaceable unit (FRU) with another.
1.
On the
Welcome
page, under the
Resources
tab, select the server.
2.
Click
Actions
>
Service and Support
>
Hardware
>
Exchange FRU
.
3.
Select an installed enclosure type from the drop-down list.
4.
From the list of FRU types for this enclosure, select a FRU type.
5.
Click
Next
to display a list of locations for the FRU type.
6.
Select the location code for a specific FRU.
7.
Click
Add
to add the FRU location to
Pending Actions
.
8.
Click
Launch Procedure
to begin replacing the FRUs listed in
Pending Actions
.
9.
Click
Finish
when you have completed the FRU installation.
Power On/Off Unit
Use this task to power on or off an IO unit.
1.
On the
Welcome
page, under the
Resources
tab, select the server.
2.
Click
Actions
>
Service and Support
>
Hardware
>
Power On/Off Unit
.
3.
Select the I/O Unit or PCI slot to either activate or deactivate for this managed server. Only units or
slots that reside in a power domain can be powered on or off. The corresponding power on/off
buttons will be disabled for location codes that are not controlled by an IBM Systems Director
Management Console
4.
Click
Power On
or
Power Off
to either activate or deactivate the I/O Unit or PCI slot respectively.
5.
Click
Advanced
if you must set advanced power functions. The advanced power functions should be
used only under the guidance of your service provider.
MES tasks
Use the tasks to perform guided repair procedures for a managed server.
Adding or removing enclosure
Use this task to install a new enclosure or remove an existing enclosure as part of an upgrade.
To install a new enclosure as part of an upgrade, complete the following steps:
1.
On the
Welcome
page, under the
Resources
tab, select the server.
Troubleshooting, service, and support using Systems Director Management Console
33
Summary of Contents for 7042-CR6
