Configuring the Ethernet controller
Use this information to configure the Ethernet controller.
The Ethernet controllers are integrated on the system board. They provide an
interface for connecting to a 10 Mbps, 100 Mbps, or 1 Gbps network and provide
full-duplex (FDX) capability, which enables simultaneous transmission and
reception of data on the network. If the Ethernet ports in the server support
auto-negotiation, the controllers detect the data-transfer rate (10BASE-T,
100BASE-TX, or 1000BASE-T) and duplex mode (full-duplex or half-duplex) of the
network and automatically operate at that rate and mode.
You do not have to set any jumpers or configure the controllers. However, you
must install a device driver to enable the operating system to address the
controllers.
To find device drivers and information about configuring the Ethernet controllers,
go to http://www.ibm.com/supportportal.
Enabling Features on Demand Ethernet software
Use this information to enable Features on Demand Ethernet software.
You can activate the Features on Demand (FoD) software upgrade key for Fibre
Channel over Ethernet (FCoE) and iSCSI storage protocols that is integrated in the
integrated management module. For more information and instructions for
activating the Features on Demand Ethernet software key, see the
IBM Features on
Demand User’s Guide
. To download the document, go to /http://www.ibm.com/
systems/x/fod/, log in, and click
Help
.
Enabling Features on Demand RAID software
Use this information to enable Features on Demand RAID software.
You can activate the Features on Demand (FoD) software upgrade key for RAID
that is integrated in the integrated management module. For more information and
instructions for activating the Features on Demand RAID software key, see the
IBM
Features on Demand User’s Guide
. To download the document, go to
/http://www.ibm.com/systems/x/fod/, log in, and click
Help
.
Configuring RAID arrays
Use the Setup utility to configure RAID arrays.
About this task
The specific procedure for configuring arrays depends on the RAID controller that
you are using. For details, see the documentation for your RAID controller. To
access the utility for your RAID controller, complete the following steps:
Procedure
1.
Turn on the server.
Note:
Approximately 10 seconds after the server is connected to power, the
power-control button becomes active.
120
System x3500 M4 Type 7383: Installation and Service Guide
Summary of Contents for 7383
