Installing the bezel
Use this information to install the bezel.
Before you begin
Read the safety information in “Safety” on page vii and “Installation guidelines”
on page 34.
If you are replacing a component or installing an optional device in the server, you
need to turn off the server and peripheral devices, and disconnect the power cords
and all external cables.
About this task
To install the bezel, complete the following steps.
Procedure
1.
Unlock the left-side cover, using the key that comes with the server.
Note:
You must unlock the left-side cover to open or remove the bezel. When
you lock the left-side cover, it locks both the cover and the bezel.
2.
Align the hinge assemblies with the hinge holes on the chassis.
3.
Push the hinges into the holes downward on the chassis until they snap into
place.
208
System x3500 M4 Type 7383: Installation and Service Guide
Summary of Contents for 7383
