The system event logs contain all event and error messages that have been
generated during POST, by the systems-management interface handler, and by
the system service processor (IMM). Run the diagnostic programs to get more
information about error codes that occur. For additional information about running
the diagnostic programs and viewing the logs, see the
Problem Determination
and Service Guide
on the IBM
System x Documentation
CD.
Important:
If the system-error LED on the front of the server is lit but there are
no other error indications, clear the IMM system-event log. Also, after you
complete a repair or correct an error, clear the IMM system-event log to turn off
the system-error LED on the front of the server.
–
POST Event Viewer
Select this choice to enter the POST event viewer to view the POST error
messages.
–
System Event Log
Select this choice to view the IMM system event log.
–
Clear System Event Log
Select this choice to clear the IMM system event log.
v
User Security
Select this choice to set, change, or clear passwords. See “Passwords” on page
110 for more information.
This choice is on the full and limited Setup utility menu.
–
Set Power-on Password
Select this choice to set or change a power-on password. See “Power-on
password” on page 110 for more information.
–
Clear Power-on Password
Select this choice to clear a power-on password. See “Power-on password”
on page 110 for more information.
–
Set Administrator Password
Attention:
If you set an administrator password and then forget it, there is
no way to change, override, or remove it. You must replace the system board.
Select this choice to set or change an administrator password. An
administrator password is intended to be used by a system administrator; it
limits access to the full Setup utility menu. If an administrator password is set,
the full Setup utility menu is available only if you type the administrator
password at the password prompt. For more information, see “Administrator
password” on page 110.
– Clear Administrator Password
Select this choice to clear an administrator password. For more information,
see “Administrator password” on page 110.
Attention:
If you set an administrator password and then forget it, there is
no way to change, override, or remove it. You must replace the system board.
v
Save Settings
Select this choice to save the changes that you have made in the settings.
v
Restore Settings
Select this choice to cancel the changes that you have made in the settings and
restore the previous settings.
v
Load Default Settings
Select this choice to cancel the changes that you have made in the settings and
restore the factory settings.
Chapter 3. Configuring the server
109
Summary of Contents for 783722U
