Completing the installation
To complete the installation, you must reinstall the side
and top covers, reconnect all the cables that you
disconnected in “Preparing to install options” on page 246,
and, for certain options, run the Configuration/Setup Utility
program.
Attention
For correct cooling and airflow, install the top cover
before turning on the server. Operating the server for
extended periods of time (over 30 minutes) with the
top cover removed might damage server components.
Installing the top cover:
Refer to the following illustration while you perform the
steps in this procedure.
.1/
Thumbscrews
.2/
Top cover
To install the server top cover:
1. Before installing a cover, check that all cables,
adapters, and other components are installed and
seated correctly and that you have not left loose tools
or parts inside the server.
2. Lower the cover
.2/
with the rear edge of the cover
about 25 mm (1 inch) back from the rear edge of the
server.
3. Slide the cover forward.
178
Netfinity Server HMM
Summary of Contents for 866251Y - Netfinity 5500 M20
