Caution
The Power Control button on the device and
the power switch do not turn off the electrical
current supplied to the device. The device also
might have more than one power cord. To
remove all electrical current from the device,
ensure that all power cords are disconnected
from the power source.
1
2
The server can be activated in several ways:
You can turn on the server by pressing the
Power Control button on the front of the
server.
Note
If you have just plugged the power cord of
the server into an electrical outlet, you will
have to wait approximately 20 seconds
before pressing the Power Control button.
If the server is activated and a power failure
occurs, the server will start automatically when
power is restored.
The server can also be powered on by the
Netfinity Advanced System Management
Processor.
The server can be deactivated as follows:
You can turn off the server by pressing the
Power Control button on the front of the
server. Pressing the Power Control button
starts an orderly shutdown of the operating
system, if this feature is supported by the
operating system, and places the server in
standby mode.
Note
After turning off the server, wait at least 5
seconds before pressing the Power
Control button to power the server on
again.
182
Netfinity Server HMM
Summary of Contents for 866251Y - Netfinity 5500 M20
