Installing a drive in a hot-swap bay:
The bays on the right front of the server support hot-swap
drives only.
Note
You do not have to turn off the server to install
hot-swap drives in these bays. However, you must
turn off the server when performing any steps that
involve installing or removing cables.
Note
Read “Safety information” on page 340.
Read the documentation that comes with the
drive.
Review “ServeRAID system board controller” on
page 66 for information about the RAID controller
and disk-array configuration.
Prepare the drive for installation (see
“Preinstallation steps (all bays)” on page 216).
Refer to the following illustration while you perform the
steps in this procedure.
.1/
Filler panel
.2/
Hot-swap hard disk drive
.3/
Drive tray handle (open position)
To install a drive in a hot-swap bay:
1. Unlock and open the server door (see “Preparing to
install options” on page 246).
220
Netfinity Server HMM
Summary of Contents for 866251Y - Netfinity 5500 M20
