Installing devices in the NetBAY3
Use the following information for installing devices in the
NetBAY3.
Note
The illustrations in this section do not show the server
on top of the NetBAY3; however, you do not need to
remove the NetBAY3 to install devices.
General considerations:
You can install three types of devices in the NetBAY3:
Devices, such as the IBM EXP10, that sit on side rails
Cantilevered devices, such as a power distribution
unit (PDU), that are screwed to the front or rear of the
NetBAY3
Devices that sit on the NetBAY3 base plate
Notes
1. To allow the NetBAY3 front bezel to close,
devices with handles must not protrude out more
than 56 cm (2.2 in.). The following illustration of
the front bezel top-view cross section shows the
clearances.
2. All device cables must exit from the rear of the
NetBAY3.
56 mm (2.2 in.)
30 mm (1.2 in.)
Removing the rear panel:
Note
Do not remove the rear panel if you are not installing
a device in the NetBAY3.
1. Remove the NetBAY3 rear panel.
a. Remove the four screws.
b. Lift the rear panel off.
Netfinity 5500 M20 - Type 8662
225
Summary of Contents for 866251Y - Netfinity 5500 M20
