Chapter 3. Planning
71
Figure 3-3 PCI-X slots in the x440
Other configuration information:
The x440 server supports connection to the RXE-100.
Refer to 3.2.3, “Remote Expansion Enclosure” on page 78 for more
information.
Video adapters are not supported.
The PCI slots supports 3.3 V adapters only.
The ServeRAID 4H adapter is not supported for internal drives because the
adapter is too high to fit in the 4U server when a cable is attached to its
internal connector.
Do not install a ServeRAID card in slot 1. This is because there is little space
between the top of the adapter and the cover when the covers are closed.
This could damage the SCSI cable. See tip H176217 at
http://www.pc.ibm.com/qtechinfo/MIGR-43804.html
for details.
The x440 comes with an additional pre-installed cable to enable the
ServeRAID adapter to connect to the internal drives.
Important: 5 V adapters are not supported.
PCI-X slot 1
(66
)
MHz
PCI-X slot 2
(66
)
MHz
PCI-X slot 3
(100
)
MHz
PCI-X slot 4
(100
)
MHz
PCI-X slot 5
(133
)
MHz
Back of server
Bus: D
B
A
C
PCI-X slot 6
(133 MHz)
Summary of Contents for 8687 - Eserver xSeries 440
