56
Intel® Server Compute Blade SBX82: Hardware Maintenance Manual and Troubleshooting Guide
— System Partition Visibility
Select this choice to specify whether the System Partition is to be visible or hidden.
— Integrated System Management Processor Settings
Select this choice to enable or disable the Reboot on System NMI option on the menu. If
you enable this option, the blade server will automatically restart 60 seconds after the
service processor issues a nonmaskable interrupt (NMI) to the blade server.
•
Save Settings
Select this choice to save the changes you have made in the settings.
•
Restore Settings
Select this choice to cancel the changes you have made in the settings and restore the previous
settings.
•
Load Default Settings
Select this choice to cancel the changes you have made in the settings and restore the factory
settings.
•
Exit Setup
Select this choice to exit from the Configuration/Setup Utility program. If you have not saved
the changes you have made in the settings, you are asked whether you want to save the changes
or exit without saving them.
Using passwords
From the System Security choice, you can set, change, and delete a power-on password.
If you set a power-on password, you must type the power-on password to complete the system
startup and to have access to the full Configuration/Setup Utility menu.
You can use any combination of up to seven characters (A–Z, a–z, and 0–9) for the password. Keep
a record of your password in a secure place.
If you forget the power-on password, you can regain access to the blade server through one of the
following methods:
•
Remove the blade server battery and then reinstall it (see “Replacing the battery” on page 39).
•
Change the position of the power-on password override switch (switch 8 on switch block 2 on
the system board) to bypass the power-on password check the next time the blade server is
turned on. You can then start the Configuration/Setup Utility program and change the power-on
password. You do not have to move the switch back to the previous position after the password is
overridden. See Figure 4 on page 14 for the location of switch block 2.
✏
NOTE
Shut down the operating system, turn off the blade server, and remove the blade server
from the SBCE unit to access the switches.
Summary of Contents for 8832L1X
Page 62: ...46 Intel Server Compute Blade SBX82 Hardware Maintenance Manual and Troubleshooting Guide...
Page 148: ...132 Intel Server Compute Blade SBX82 Hardware Maintenance Manual and Troubleshooting Guide...
Page 154: ...138 Intel Server Compute Blade SBX82 Hardware Maintenance Manual and Troubleshooting Guide...
