11.6
11.7
11.8
11.9
At the login prompt, enter the following default user ID and password:
In the navigation area, expand
.
Click
.
Select
in the Boot to system server firmware field.
Click
.
Power/Restart Control
Power On/Off System
Standby
Save settings and power on
User ID
admin
Password
admin
Configure the Ethernet interface on the PC to an IP address and subnet mask
within the same subnet as the server. This is the IP address for the service
processor.
Server connector
HMC1
HMC2
Subnet mask
255.255.255.0
255.255.255.0
IP address
192.168.2.147
192.168.3.147
For example, if you connected your PC to HMC1, the IP address for your service
processor might be 192.168.2.1 and the subnet mask would be 255.255.255.0. Set
the gateway IP address to the same IP address as that of the PC.
Using a Web browser, enter the IP address into the
field that corresponds
to the port to which your PC is connected. For example, enter https://192.168.2.147.
Address
Possible values:
Note
:
If you do not know how to do this, see the instructions in the IBM Systems
Hardware Information Center. For details about how to access the information
center, see task 12
Finish your system setup.
When you are prompted, change the default password.
1.
2.
3.
4.
Change the state of the system server firmware.
11.10
