7.6
Start the Operations Console configuration wizard on the system console.
Click
.
Follow the steps in the wizard. Use the following information to enter any required data.
Start > Programs > iSeries Access for Windows > Operations Console
Service host name
(interface name):
Target partition:
Service tools device ID:
Access password:
Serial Number:
Use either the name of a current network interface, or a new
name for this connection.
Enter the number , even if you are not partitioning.
Use the default value
.
Enter a password that you will remember. The password is case
sensitive and can be a maximum of 128 characters.
1
QCONSOLE
Enter the serial number located on the server control panel.
Click
to save the configuration and to exit the configuration wizard.
Finish
1.
2.
3.
7.8
Connect your server to a power source. The control panel should be lit and display
. The server is not yet powered on.
If
does not display, see the instructions in the IBM Systems Hardware
Information Center. For details about how to access the information center, see task 11
.
01 B
N V=F
01 B N V=F
Note:
Finish your system setup
7.7
Right-click the connection name and select
to start your connection. The system
console will not complete the connection until you have completed step 7.10.
Connect
7.9
Press the white Power On button on the front of the server. There is a short delay before
the server powers on, of approximately 5 to 20 minutes. When the server powers on, the
control panel displays
.
01 B N V=F
7.10
When the LAN Service Tools Sign-on window is displayed, type your access password,
and then type (eight 1's) in both the service tools user ID and password fields.
11111111
You have completed the basic setup. Go to task 11
.
Finish your system setup
