Install the slide rail assemblies
4
4.1
4.2
Locate the rack-mounting template, the rack-mounting hardware kit, and the slide rail
assemblies that were included with your server.
Use the rack-mounting template to determine where in the rack to place the server. Remove
any filler panels necessary to allow adequate access to the location where you will install
your server.
If you do not have enough space around your rack to open the front and back doors completely, remove
the doors before starting this task to allow adequate access.
4.3
Follow the rack-mounting template to mark the location on
the rack where you will place the server. Use the self-
adhesive placement dots found on the rack-mounting
template.
4.4
Pull the back latch-assembly
release tabs
to the retracted
position and lock the latch
assembly . Make sure the
alignment pins
that are
located on the back of the slide
rail are fully retracted.
C
B
D
From the back of the rack,
insert the front alignment pin
into the hole in the front of the
rack, as identified by the self-
adhesive placement dot.
D
1.
2.
Install the slide rail assemblies .
A
Note:
Install units into the lower part of the rack first. Place
larger and heavier units in the lower part of the rack.
C
B
Front
Back
A
D
