Mouse
Note: A sticking keybutton can cause the mouse to operate incorrectly. If
you suspect this, go to “Keyboard” on page 2-42.
001
– Insert the Diagnostics and Utilities CD into the CD-ROM drive.
– Power-off the system unit.
– Make sure the mouse connector is connected to the proper port.
– Make sure the mouse ball turns freely.
– If you have a cordless mouse:
Make sure the batteries are not dead in the mouse.
Try resetting the mouse and receiver by moving the receiver switch
switch to Two, then back to One. For more information see the IBM
Aptiva Cordless Mouse User's Guide.
– Power-on the system unit.
– Make a note of any error messages, then press Esc.
– Select Advanced Diagnostics from the Main Menu.
– Select Diagnostics from the Main Menu.
– Select Module Tests from the menu.
– Select Pointer Device from the menu.
– Follow the prompts and perform the test.
DO THE MOUSE DIAGNOSTIC TESTS RUN WITHOUT ERRORS?
Yes No
002
– If you receive any error
except an 8613 error replace the mouse.
– If you receive an 8613 error, replace the system board.
003
– The system unit is operating normally.
– If the symptom remains, replace the mouse.
2-44
Summary of Contents for Aptiva 2162 Series
