Model 6E4 Back Cover Replacement
To replace the back cover, do the following:
1. Ensure all cables have been connected and are correctly seated.
2. Align the back cover side edges with the side edges of the system chassis back.
3. Raise the back cover about 1 inch higher than the system, ensuring tab to slot
clearance.
4. Push the back cover straight down. This seats the tabs into their retaining slots.
Disk Drive Access Cover Removal
To remove the disk drive access cover on a Model 6E4, do the following:
1. Open the bezel door.
2. Locate the disk drive access cover on the front bezel of the system. As shown in
the following illustration.
3. Press down on the release tab located at the top of the access cover.
4. Gently pull the top of the access cover out and away from the system.
Note: Lift up the two alignments tabs located on the bottom front edge of the
access cover, then lift them out of their slots.
5. Put the cover in a safe place.
1 Model 6E4
4 Disk Drive Access Cover
2 Bezel Door
5 Alignment Tabs
3 Disk Drive Access Cover Release
Tab
Disk Drive Access Cover Replacement
To replace the disk drive access cover on a Model 6E4, do the following:
1. Insert the two alignment tabs, located on the bottom front edge of the access cover,
into the two slots located on the front bezel.
2. With the alignment tabs inserted into the slots, pivot the access cover up until the
release tab clicks into the closed position.
3. Close the bezel door.
Chapter 4. Installing Options
59
Summary of Contents for @Server pSeries 630 6C4
