v
Exit Setup
Select this choice to exit from the Configuration/Setup Utility program. If you have
not saved the changes you have made in the settings, you are asked whether
you want to save the changes or exit without saving them.
Using passwords
From the
System Security
choice, you can set, change, and delete a power-on
password.
Power-on password
If you set a power-on password, you must type the power-on password to complete
the system startup, and you have access to the full Configuration/Setup Utility
menu.
You can use any combination of up to seven characters (A–Z, a–z, and 0–9) for the
password. Keep a record of your password in a secure place.
If you forget the power-on password, you can regain access to the blade server
through one of the following methods:
v
Remove the blade server battery and then reinstall it (see “Replacing the battery”
on page 36).
v
Change the position of the power-on password override switch (switch 8 on
switch block 2 on the system board) to bypass the power-on password check the
next time the blade server is turned on. You can then start the
Configuration/Setup Utility program and change the power-on password. You do
not need to move the switch back to the previous position after the password is
overridden. See “Switches and jumpers” on page 11 for the location of switch
block 2.
Note:
Shut down the operating system, turn off the blade server, and remove the
blade server from the BladeCenter unit to access the switches.
Using the PXE boot agent utility program
This program is a built-in, menu-driven configuration utility program that you can
use to:
v
Select the boot protocol and other boot options
v
Select whether to display the PXE setup prompt and the display duration
v
Select a power management option
Note:
The RPL selection for the boot protocol option is not supported for this
server.
Starting the PXE boot agent utility program
Complete the following steps to start the PXE boot agent utility program:
1. Turn on the server.
2. When the
Broadcom NetXtreme Boot Agent vX.X.X
prompt appears, press
Ctrl+S.
Notes:
a. If the PXE setup prompt is not displayed, use the Configuration/Setup Utility
program to set the enable Ethernet PXE/DHCP option.
48
BladeCenter HS20 Type 8832: Installation and User’s Guide
Summary of Contents for BladeCanter HS20
