7.
Place the drive into the hard disk drive tray and push it toward the rear of the
blade, into the connector until the drive moves past the lever at the front of the
tray.
Attention:
Do not press on the top of the drive. Pressing the top might
damage the drive.
8.
Install and close the blade server cover. See “Installing and closing the blade
server cover” on page 243.
Statement 21
CAUTION:
Hazardous energy is present when the blade server is connected to the power
source. Always replace the blade server cover before installing the blade
server.
9.
Install the blade server into the BladeCenter unit. See “Installing the blade
server in a BladeCenter unit” on page 240.
Removing a memory module
Remove a dual-inline memory module (DIMM).
1.
Read “Safety” on page v and the “Installation guidelines” on page 237.
2.
Shut down the operating system, turn off the blade server, and remove the
blade server from the BladeCenter unit. See “Removing the blade server from a
BladeCenter unit” on page 239.
3.
Carefully lay the blade server on a flat, static-protective surface, with the cover
side up.
4.
Open and remove the blade server cover. See “Removing the blade server
cover” on page 242.
DIMM
Retaining clip
Figure 14. Removing a memory module
248
JS22 Type 7998: Problem Determination and Service Guide
Summary of Contents for BladeCenter JS22
