Before you begin
Read “Safety” on page v and “Installation guidelines” on page 73 before
performing this procedure.
About this task
Captive thumb
screws
Release latch
Release handle
Shipping screws
Shuttle
Procedure
1.
Shut down the operating systems and turn off any blade servers in the
BladeCenter S chassis. See the documentation that comes with the blade
server for detailed instructions.
2.
Disengage the blade servers from the front of the BladeCenter S chassis by
opening the release handles on all blade servers.
3.
Disengage the media tray from the front of the BladeCenter S chassis by
opening the release handle.
4.
Disengage the storage modulesfrom the front of the BladeCenter S chassis by
opening the release handle on each storage module.
5.
Disconnect the power from the BladeCenter S chassis.
6.
Disconnect all cables from the modules in the rear of the BladeCenter S
chassis.
7.
Remove any of the following modules that are installed in the rear of the
BladeCenter S chassis:
v
I/O modules (see “Removing an I/O module” on page 93).
v
Advanced management module (see “Removing an advanced management
module” on page 88).
v
Serial pass-thru module (see “Removing a serial pass-thru module” on page
97).
v
Fan modules (see “Removing a fan module” on page 92).
v
Power supplies (see “Removing a power module” on page 95).
8.
Remove the left and right shipping brackets from the BladeCenter S chassis
and the rack, if they are installed.
Chapter 4. Removing and replacing BladeCenter components
101
Summary of Contents for BladeCenter S
