Air damper
Retainer clip
Installing an air damper
The installation of an air damper should only be performed by a trained service
technician.
Before you begin
Read “Safety” on page v and “Installation guidelines” on page 73 before
performing this procedure.
About this task
There is an air damper inside each of the BladeCenter S chassis blade server bays.
Perform these steps to install the air damper.
Procedure
1.
Make sure all blade servers are removed from the BladeCenter S chassis, and
that it is disconnected from power.
2.
From the rear of the BladeCenter S chassis, slide the air damper into the air
damper slot towards the front of the chassis.
Chapter 4. Removing and replacing BladeCenter components
111
Summary of Contents for BladeCenter S
