Chapter 1. Disk attachment technology
11
Draft Document for Review March 28, 2011 12:24 pm
7914DiskAttach0908.fm
The format of a NASA is naa plus NASA 64 or 128 bit identifier. For example:
naa.52004567BA64678D
iSCSI addressing
Usually an iSCSI participant can be defined by three or four fields:
1. Hostname or IP Address (e.g., “iscsi.example.com”)
2. Port Number (e.g., 3260)
3. iSCSI Name (e.g., the IQN "iqn.2003-01.com.ibm:00.fcd0ab21.shark128")
4. An optional CHAP Secret (e.g., "secrets")
The iSCSI address can have the following format.
<IP address>[:<port>]/<iSCSI name>
The IP address can be either IPv4, IPv6, or the fully qualified domain name. The <port> is
optional; it specifies the TCP port that the target is listening for connections on. If it is not
used, the well-known iSCSI port (3260) is assumed. The <iSCSI name> is the IQN or EUI
name of the device. It is optional.
The iSCSI address specifies a single path to an iSCSI target. The iSCSI address is primarily
used during discovery.
1.3.2 iSCSI discovery
iSCSI discovery allows an initiator to find the target(s) to which it has access. This requires a
minimum of user configuration. Several methods of discovery may be used:
A list of targets at the initiator
An administrator can statically define the iSCSI targets to the host system initiator. This
process allows the administrator to specify the iSCSI target node name and IP address:port
to the host system initiator or its host bus adapter (HBA). iSCSI HBAs should support an
administrator defining this information. This type of discovery is useful in small installations
and is known as
static discovery
.
Queries to known iSCSI servers
An iSCSI initiator can probe its environment and, when a possible iSCSI target is found, start
a
discovery session
with the target by issuing a
SendTargets
command. The target can reply
to a
SendTargets
command by returning a list of all iSCSI target nodes it knows about.
Queries to an Internet Storage Name Server (iSNS)
The Internet Storage Name Server permits iSCSI targets to register with a central point. The
administrator can set up discovery domains so that when a host iSCSI initiator queries the
central control point for the locations of iSCSI storage controllers, only the authorized
controllers are reported. The iSNS server can be located by one of the following techniques:
iSCSI initiators multicasting to the iSNS server
Setting the iSNS server IP address in the DHCP server
Setting the iSNS server IP address in the iSCSI initiator or target
Setting the iSNS server IP address in the SLP server (see “Service Location Protocol
(SLP)” on page 12)
Summary of Contents for DS3500
Page 2: ......
Page 5: ...iii Draft Document for Review March 28 2011 12 24 pm 7914edno fm ...
Page 789: ......
