7914support2-0209.fm
Draft Document for Review March 28, 2011 12:24 pm
398
IBM System Storage DS3500: Introduction and Implementation Guide
Component Type: The type of component that is affected by the event. The component
type might indicate a physical component, such as a disk drive, or a logical component,
such as a logical drive.
Component Location: The location of the component that is affected by the event. The
location shows the enclosure or slot for the component.
Logged by: The name of the controller that logged the event.
Raw Data: Information that is used by an IBM Support representative.
In the right upper corner, you can set how many events to display; the default initial value is
100. To change this, enter another value and click Update (Figure 14-93). The bottom left
hand part of the window shows the total number of events stored on the subsystem. The
maximum number of event is 8191. If more events occur, the old events are removed from the
log on a first in, first out basis.
Figure 14-93 Change the number of recent events to display
In the left upper corner are two check boxes:
View only critical events: Check this to display only the critical events, as shown in
Figure 14-94.
Figure 14-94 View only Critical Events
The buttons at the bottom of the window are:
Select All: Use this button to highlight all events (Figure 14-95 on page 399).
Summary of Contents for DS3500
Page 2: ......
Page 5: ...iii Draft Document for Review March 28 2011 12 24 pm 7914edno fm ...
Page 789: ......
